Instructions / Assembly

ManualsBrandsNew England Arbors ManualsLumber & CompositesCountry Corner Picket

Part # Description Quantity

Assembly & Mounting Instructions

Country Corner Picket

- Read instructions through carefully before

beginning assembly.

- Identify each component from material list.

- When assembling components, place on a

non-abrasive surface to avoid scratches.

- Do not use excessive force when assembling

components.

- In the event of missing or defective parts,

please call our customer service department

at 1-800-282-9346 (ext.#20).

General Information:

- Tape measure

- Level

- Shovel

Tools Required:

1 3 1/2” sq. x 38” End posts

2 3 1/2” sq. x 43” Corner post

3 1 3/4” sq. x 44 3/4” Top rails

4 1 3/4” sq. x 44 3/4” Bottom rails

5 7/8” x 3” x 18” Pickets

6 7/8” x 3” x 19” Pickets

7 7/8” x 3” x 20 1/2” Pickets

8 7/8” x 3” x 23” Pickets

9 Hardware kit (Includes):

7/8” x 3” Picket Caps

3 1/2” sq. Post Caps

- Bags of pre-mix concrete *

* Recommended for extra stability.

Materials Included:

Materials (Optional): (Not Included)

Part 2

(Fig. 1)

Product dimensions & part

identification.

(Fig. 2)

Post layout for installation.

Part 1

Part 3

Part 4

Part 5

Part 6

Part 7

Part 8

Post Cap

Picket Cap

(In 1 box)

Made in Canada

Ver 1.07

26.5”

31.5”

48”

41”

IMPORTANT NOTICE:

If you have purchased an extension kit, prior to the

assembly of the corner unit, the end posts included in

this box must be switched with the rail posts of the

extension kit.

Summary of content (3 pages)

PAGE 1
Country Corner Picket Assembly & Mounting Instructions IMPORTANT NOTICE: If you have purchased an extension kit, prior to the assembly of the corner unit, the end posts included in this box must be switched with the rail posts of the extension kit. General Information: - Read instructions through carefully before beginning assembly. - Identify each component from material list. - When assembling components, place on a non-abrasive surface to avoid scratches.
PAGE 2
1 Lay out one of the end posts (part 1) and insert a bottom rail (part 4) into the bottom hole in the post. Make sure the holes in the rail are facing the other hole in the end post, and push the rail in past the locking tabs. Note: the hole which measures 19” from the end of the post is the bottom hole. 2 Insert one of the top rails (part 3) into the second hole in the end post. Push the rail in past the locking tabs. 3 Repeat steps 1 and 2 for the remaining end post, top and bottom rail.
PAGE 3
7 As in step 6, slip each of the remaining pickets through the next five holes on either side of the corner post. Insert the pickets in decending order, ending with three 18” pickets (part 5) on each side. 8 Insert a picket cap into the open end of the picket and press down firmly. Repeat this step for the remaining 11 pickets. Note: if desired, use a PVC type of glue (not included) to permanently glue the picket caps. You can find this glue in most stores that have an extensive plumbing department.