Installation Guide

134 in.
340.4 cm.
135 5/8 in.
344.4 cm.
Main Support Beam Assembly
Insert one 2x6x12 pressure treated wood into a beam followed
by the joiner and another beam section. Center the 2x6x12 within
the main support beam assembly.
Critical Note:
Note the location of the pre-drilled holes on the end of the main
support beams. As pictured aside, the holes should be away from
the joiners.
Screw the joiner to vinyl beams and wood insert using 1 1/2”
screws.
Using a 1/2” drill bit, drill through the pre-drilled holes through
the 2x6 wood as shown.
Repeat for second Main Support Beam assembly.
1
2
3
STEP FOUR
10
12 x 12 Flat Top Attached Louvered Pergola
At this stage, the columns should be properly
installed as per the following illustration,
with the columns 134” in. (340.4 cm) apart.
Critical: Note the opening direction
of the holes on the top of the posts.
2
1
Pre-drilled hole
at the end of the
main support beam
Pre-drilled hole
at the end of the
main support beam
3
4