Installation Guide

Main Support Beam Assembly

Using four 1 1/2” (38mm) screws provided, fasten the Beam Joiners,

Main Support Beam, and Wood together as shown.

Now that the wood is secured in place, use the 1/2“ (13mm) predrilled

holes as templates and drill 1/2” (13 mm) holes through the wood as

shown. Make sure to drill straight through to the other side of the main

support beam.

Note: Do not pre-drill the 1/8" screw holes through the wood. The 4"

(102 mm) self-auguring screws provided will be set through the main

beams when securing the beams to the columns.

Repeat for all four main support beams.

Rafter Assembly

STEP FIVE

To accomodate the notches on the rafters, first the wood inserts

must be notched out as shown below:

Six will be needed.

7 in (18cm)

minimum

3½” (90 mm)

144 in (365 cm)

3½” (90mm)

7 in (18cm)

minimum

12 x 12 Flat Top Louvered Pergola