Maintenance of shower panel HIGH END SANITARY WARES Before using our shower pane], please fully read the instructions carefully. The instructions and safety information in this document are essential ta the safe operation of your new unit.
[RENEE — ih Overhead rainfall mower i) N Overhead rainfall shower — ii “0 Body jets Co Handheld shower wand Multi-position diverted valve—: Main switch—— General valve Thermostatic valve! Tos temperature is adjustable ky switching the thermostatic velvety LE ia Note, thermostatic shower panel with common shower panel installation lo the same, constant temperature faucet of the inlet pipe fo connect right, Red hot water hose, green hose cold water.
Plumbing Requirements, -Flow rate. 2.5 gallons per minute (gpm) —~Water pressure, 60 to 80 psi for both cold and hot supply lines You will have to speak with a plumber regarding the installation of a booster pump or enlarging your supply lines if your water supply in unable to meet the requirements above. ‘While mounting the brackets of your new shower panel, the following will influence your decision on which height to mount the unit at.
The following picture ia the installation IMPORTANT. Before connecting the hoses to the water supply lines, please clean the hoses with water. Then connect the hoses to the water supply lines and check the leaks, if no leaks, you may move on to the next process. You can hang your shower panel on the mounting brackets you installed when you are done checking for leaks. 1.
he assembly and disassembly steps of thermostatic shower panel Assembly steps 1.Put the valve core back into the valve. | 4.Put the valve cover on. 3.To put the metal ring back Fat The red lines on the same line = | ot 2.Put the brass rim onto the valve core. The thermostatic faucet sets the mixture between the cold and hot water in the unit.