2 A B A 技术 要求: 1.印刷 颜色 为PANTONE BLACK C 2.规格 为A4 3.如果 供应 商的 排版 需要 加空 白页,请 加在 最后 B C C 借 ( 通 ) 用件登记 描 图 描 校 英文用 户手 册 IDW450MK2(9337A) BELLING英国 旧底图总号 底图总号 签 日 字 期 标记 处数 设 计 审 核 工 艺 标准化 1 更改文件号 签 名 校对 审定 批准 日期 日期 比例 阶段标记 REV.
IDW450MK2
For detailed operating method read the corresponding content on the instruction manual. Switch on the appliance Fill the detergent dispenser Check the rinse aid level Check the regeneration salt level Load the baskets Select a programme Running the dishwasher Changing the programme Press the On/Off button to switch on the appliance, Open the door. With each wash cycle. Compartment For programmes with pre-wash only.
Dear Customer, This appliance is intended to be used in household and similar applications such as: -staff kitchen areas in shops, offices and other wor king environments; -far m houses; -by clients in hotels, motels and ot her residential type environments; -bed and breakfast type environments. Please carefully read this manual bef ore using the dishwasher, it will help you to use and maintain the dishwasher properly. Keep it to refer to it at a later date.
When using your dishwasher, follow the precautions listed below: This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of anelectric shock by providing a path of least resistance of electric current. This appliance is equipped with a cord having an equipmentgrounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances.
Dispo se of the dishwasher packaging material correctly. All pa ckaging materials ca n be recycled. Plastic parts are marked with the standard international abbreviations: PE for polyethylene, e .g. sheet wrapping material PS for polysty rene, e.g. padding material POM PP ABS po lyoxymethylene, e.g. pla stic clips polypropylene, e.g. Salt filler Acrylonitrile Butadiene Styrene, e.g. Control Panel .
To get the best performance from your dishwasher, read all operating instructions before using it for the first time. IDW450 5 2 3 4 2 Display window: Program remaining time, delay time, running indicator, Program indicator, Salt and rinse aid indicator, Error codes, etc. Dela yed Start Bu tton: To preset the wash timer and delay the starting time up to 24 hours. Every press of this button increase s the time by one hour. (for example: one press for an hour, two for two hours... ...
Before using your dishwasher for the first time: A. Set the water softener B. Pour 1/2 litre of water inside the salt container and then fill with d ishwash er salt C. Fill the rinse aid dispenser D. Fill in detergent The water softener must be set manually, using the water hardness dial. The water softener is designed to remove minerals and salts from the water, which would have a detrimental or adverse effect on the operation of the appliance.
Always use the salt intended for use with dishwasher. The salt contain er is located beneath the lower basket and should be fill ed as explained in t he foll owing: Attention! Only use salt spe cif ically desi gne d for t he use i n dishwashers! Every other type of salt not speci fically de sig ned fo r the u se in a d ishwasher, espe cially table salt, will damage the w ater sof tener.
When to Refill the Rinse Aid Dispenser If there is no rinse-aid warning light in the control panel, you can estimate the amount from the colour of the optical level indicator " C "located next to the cap. When th e rinse-aid c ontainer is full, the whole indicator will be dark .As the rinse -aid diminishes, the size of the dark dot decreases. You should never let the rinse aid leve l fall 1 / 4 full.
Normally new pulverised detergent is with out phosphate. Thus the water softener function of phosphate is not given. In this case we recommend to fill salt in the salt con taine r even when the hardness of water is only 6 °dH. If dete rgents witho ut phosphate are used in the case of hard water often white spots appear on d ishes and glasses. In this case please add more detergent to reach better results. Detergents without chlorine do only bleach a little.
Fill in Detergent Fill the detergent dispenser with detergent. The marking indicate s the dosing levels , as illustrate d on the righ t: A B The place of main wash cycle deterg ent placed , “MIN”me ans approximately 20g of detergent. The place of pre-wash cycle deterge nt placed , approximately 5g o f detergent Plea se o bserve the manufacturers dosing and storage Recommendations as stated on the detergent pac kaging. Close the lid and press until it locks in place.
Consider buying utensils which are identified as dishwasher-proof. Use a mild detergent that is described as 'kind to dishes'. If necessary, seek further information from the detergent manufacturers. For particular items, select a program with as low a temperature as possible. To prevent damage, do not take gla ss a nd c utlery out of the dishwasher immediately after the programme h as ended.
The upper basket is designed to hold more delicate and lighter dishware such as glasses, coffee and tea cups and sau cers, as well as plates, small bowls and shallow pans (as long as th ey a re not too dirty). Position the dishes and cookware so that they will not get moved by the spray o f water.
Adjusting the Upper Basket The height of the upper basket can be adjusted in order to create more space for large utensils both for the upper/lower basket. The height of the upper basket can be adjusted by placing the wheels on different h eight of the rails. Long items, serving cutlery, salad servers and knives should be placed on the shelf so that they do not obstruct the rotation of the spray arms. The shelf can be folded back or be removed when not requ ired for use.
( ) Means: need to fill rinse into the Rinse-Aid Dispenser. For heaviest soiled crockery, and normally soiled pots、 pans、dishes etc with dried on soiling. Pre-wash(50℃) Pre-wash Wash (65 ℃) Rinse Rinse Rinse (55 ℃) Drying 4/23 g (or 3in1) 120 1.2 18 For normally soiled loads, such as pots、plates、 glasses and lightly soiled pans. Pre-wash(50 ℃) Wash (50 ℃) Rinse Rinse(65 ℃) Drying 4/23g (or 3in1 ) 150 0.95 13 Standard daily cycle for normally soiled loads, such as pots、plates、 glasses.
1 Draw out the lower and up per b asket, load the dishes and push them back. It is commended to lo ad the lower bask et first, then the upper one (s ee the sectio n entitled “Loading the Dishwasher”). 2 Pour in the detergent (see the section e ntitled“Salt, Detergent and Rinse Aid”). 3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of th e socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
The filter prevents larger remnants of food or other objects from getting inside the pum. The residues may block the filter, in this case they must be removed. The filter system consists of a coarse filter,a flat (Main filter) And a microfilter(Fine filter). Main filter 2 1 Fo od and soil particles trap ped in this filter are pulverized by a specia l jet on the lower spray arm and washed down to drain.
Remarks: - Inspect the filters for blo cking a fter e very time the dishwa sher has been used. - By unscrewing the coarse filter, you can remove the filter system. Re move any foo d remna nts and clean the filters under running water. The entire filter assembly should be cleaned once a week. Cleaning the Filter To clean the coarse filter and the fine filter, use a c leaning b rush.
After Every Wash When not in Use for a LongTime After every wash, turn off the water supply to the appliance and leave the door slightly open so that moisture and odours are not trapped inside. It is recommend that you run a was h cy cle with the dishwasher empty an d the n remove the plug from the socket, turn off the wa ter supply and leave the door of the appliance slightly open. This will help the d oor seals to last longer and prevent odours from forming within the appliance.
【Figure1】 Cabinet dimensions Less than 5mm between the top of dishwasher and cabinet and the outer door aligned to cabinet. 90 ° 90 ° 820mm 580mm Electrical, drain and water supply line entrances 80 100 Space between cabinet bottom and floor 450 mm 【Figure2】 Dishwasher Minimum space when the door is opened Cabinet Door of dishwasher Minimum space of 50mm 1 The aesthetic wooden panel could be processed according to the Figure 3.
2 Install the hook on the aesthetic wooden panel and put the hook into the slot of the outer door of dishwasher(see figure 4a). After positioning of the panel , fix the panel onto the outer door by screws and bolts(See figure 4b) . Hop hook 【Figure4a】 Installation of aesthetic panel St4 countersunk head screw Lower hook 【Figure4b】 4X18 screw Cover Installation of aesthetic wooden panel Spacer for furniture door 1. Take away the cover 2. Pin up the screw 3.
● Tension adjustment of the door spring The door springs are set at the factory to the proper tension for the outer door. If aesthetic wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5). Adjust the door spring tension until the door remains balance in the fully-opened position.
● Dishwasher installation steps 1 Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the template for positioning of the brackets. 2 Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the left and right door springs. Failure to do this could cause damage to your dishwasher (Illustration 2). 3 Connect the inlet hose to the cold water supply . 4 Connect the drain hose. Refer to diagram.
Dishwasher must be level for proper dish rack operation and wash performance. 1 Place level on door and rack track inside the tub as shown to check that the dishwasher is level. 2 level the dishwasher by adjusting the four leveling legs individually. 3 When level the dishwasher, please pay attention not to let the dishwasher tip over. 【Figure 8】 Illustration of feet adjustment NOTE: The maximum adjustment height of the feet is 60 mm.
Please close the hydrant after using. Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place. If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear. This precaution is needed to avoid the risk of the water inlet to be blocked and damage the appliance. Positioning the Appliance Position the appliance in the desired location.
Fuse blown, or the circuit breaker acted Replace fuse or reset circuit breaker. Remove any other appliances sharing the same circuit with the dishwasher Power supply is not turned on Make sure the dishwasher is turned on and the door is closed securely. Make sure the power cord is properly plugged into the wall socket. Error code:E1; Water pressure is low Check that the water supply is connected properly and the water is turned on. Door of dishwasher not properly closed.
The dishes were not loaded correctly. See notes in " Loading the Dishwasher Baskets ". The programme was not powerful enough. Select a more intensive programme. See" Wash Cycle Table ". Not enough detergent was dispensed. Use more detergent, or change your detergent. Items are blocking the path of spray arms. Rearrange the items so that the spray can rotate freely. The filter combination in the base of wash cabinet is not clean or is not correctly fitted.
Height : Width : Depth : Voltage connected Load : Water pressure: Power supply: Capacity: 820mm(adjustable+60mm) 445mm 540mm see rating label 0.04-1.
Technical Data Sheet Sheet of household dishwasher according to EU Directive 1059/2010: Manufac turer BELLING Type / Description IDW45 0MK2 Stan dard place s ettings 8 Energy efficiency class A Annual e nergy consumption 228 kWh Energy consumption of the standard cleaning cycle 0.81 kWh Power consu mption of off-mode 0W Power consu mption of left-on mode 1.
Additional features of this dishwasher are: 6 wash programs Overflow protection Your dishwasher has an overfill protection program which automatica lly shuts off the inlet va lve and starts the drain pump if the water is overflowing . You can choose de sired program according to the soiled level . 8 place settings Time delay feature Be sufficient for normal use.