Instruction Manual

11
Installing your Cooker Hood
Bringing it all together
Electric Connection
The appliance has been manufactured as Class I,
therefore earth cable is necessary
The connection to the mains is carried as follows:
If the plug is not provided, connect the electrical load as indicated
on the description label. When a plug is provided, the cooker
hood must be installed in order that the plug is easy to access.
An omni polar switch with minimum aperture of 3mm between
contacts; in line with the electrical load and local standards, must
be placed between the appliance and the network in the case of
direct connection to the electrical network.
The minimum distance between the support surfaces of the
cooking pots on the hob top and the lowest part of the cooker
hood must be at least 65cm. If a connection tube composed of
two parts is used, the upper part must be placed outside the lower
part.
Do not connect the cooker hood exhaust to the same conductor
used to circulate hot air or for evacuating fumes from other
appliances generated by other than an electrical source.
Before proceeding with thew assembly oeprations, remove the
anti-grease filter(s) so that the unit is easier to handle.
In the case of assembly the appliance, in the suction version
prepare thew hole for evacuation of the air.