Installation Guide

23
Installing the 75 Ft. EPDM Flooring Edge Trims
Evenly apply weights to the installed end trim to secure the product in place while sealant
cures. Follow step 5 after each strip is installed.
Note: Use a clean damp cloth to remove any excess glue.
5
Continue installing all remaining end trim strips to the wall, and remember to miter all
required edges in 45 degrees. As you continue to install, remember to evenly add weights to
the installed trims.
6
Note: For a better corner install, add some sealant to the mittered edge, so both strips are
permanently connected.