Installation Guide

1. For Stainless Steel Top:
Install (4) #8 x 1” screws in the
locator holes along the edge of the
worktop, 3/4 of the way in.
3. Slide the tray down over the screws
and tighten with a screwdriver to
secure the tray to the workbench.
Insert screwdriver through
the access holes for easy
installation.
4. Thread in the leveling feet and
adjust as needed for leveling the
workbench.
5. Insert tray dividers in the desired
locations.
2. Slide the keyholes on the side of the
tray over the heads of the screws.
AA
SECTION A-A
SCALE 1 : 2
+
TRAY
WORKTOP
Side View
KEYHOLE ON TRAY
MARK CENTER HERE
Installing Bamboo Top Tray
Fig.1
Mounting
The Tool Tray
Fig.2
For Bamboo Top:
Place tray flush with the top of
worktop (Figure 1) and use the tray
as a guide to mark the center of the
top of the keyholes for the 4 screw
locations along the edge. (Figure 2)
Drill 1/16” pilot hole and install
screws 3/4 of the way in.
1
2
3
4
5