How to Guide

Warning:

Make sure the Lag Screws

are tight against the stud

but DO NOT over-tighten

the lag screws.

If lag screws are over-

tightened, the lag screw

could snap or the hole

may be stripped.

Installing Wall Brackets & Back Beam

Masonry

• Follow steps 1 to 11.

• Drill pilot holes through the marked locations with hammer drill & 5/16” masonry bit.

• Use Concrete Anchor for each pilot hole.

Start installation with the middle

hanging bracket.

Align the bottom of the Wall Mounting

Bracket (#6) with the bottom level line and

the center of the wall stud with the center

of the horizontal slot in the mounting

bracket (mark the hole to be drilled)

Drill a pilot hole using a 3/16” drill bit.

Note: Pilot hole must bore into 3 inches

of solid wood for lag screw to be fully

secured.

8ft Wide Wall Mounted Shelf: Insert two carriage bolts (#8) into the middle wall

mounting bracket. Secure wall mounting bracket to stud using one 3in Lag Screw (#17),

one 1/4” washer (#9) and 7/16” socket. Note: If connecting 2 or more Wall Mounted

Shelves horizontally, refer to pg 26 before installing bracket.