Installation Guide

14
• Follow steps 3 to 5.
• Drill 4 pilot holes through the
perforated strip with hammer drill &
masonry bit.
• Use 4 x (2 ¼” x ¼” )Tapcon Concrete
Anchor into wall. (Not Included)
• OR 4 x (#10 x 2” )Screw with 3/16”
masonry plug into wall. (Not Included)
• Follow Step 6.
Wall Screw
(¼” x 2½”)
Wall Washer
(¼”)
Masonry.
Base, Locker, Tool and Wall: 4 wall screws and 4
washers
Corner Wall: 6 wall screws and 6 washers
Note:
Do not load cabinet
without rst securing to
the wall.
Securing Cabinets on
Studded Wall
1
Level cabinet.
Gather parts.
2
Align cabinet
to stud marks.
Use stud nder to locate the studs
and mark the wall with a pencil.
4
3
5
Place cabinet tight
against the wall.
X4
6
Pre-drill (4) 1/4” (6.5mm) then drill
4 wall screws and washers through
perforated holes into studs.