Installation Guide

12
Use stud nder to locate the studs
and mark a line on the wall with a pencil
at desired height.
5
Hanging Cabinets on
Studded Wall
1
Gather parts.
2
• Follow steps 3 to 5.
• Drill 4 pilot holes through the perforated
strip with hammer drill & masonry bit.
• Use 4 x (2 ¼” x ¼” )Tapcon Concrete
Anchor into wall. (Not Included)
• OR 4 x (#10 x 2” )Screw with 3/16”
masonry plug into wall. (Not Included)
• Follow Step 6.
Wall Screw
(1/4” x 2.5”)
Wall Washer
(1/4”)
Masonry.
Attach remaining base cabinets (2),
and wall cabinets(3) to wall using same
method as locker cabinet(1)attachment.
4 Wall Screws per cabinet
4 Washers per cabinet
Note:
Do not load cabinet
without rst securing to
the wall.
Begin by attaching locker to wall. Line up
top of cabinet with pencil line(1), and pre-
drill 3/16” (6mm) holes into studs through
holes in cabinet(2). Use wall screws to
secure to wall(3).
4
3
D
e
t
e
r
mined H
e
ight
1
2
3
1
2
3
Finish by fastening cabinets together.
See page 15 for detailed instructions.
4 X
per Cabinet
4 X
per Cabinet
4 X
per Cabinet