How to Guide

2ft Cross Support Assembly

Grid Supports & Wire Grids Installation

(i) Assemble the 2ft Cross Supports (#14) with one 1/4” hex bolt (#15) and 1/4” lock nut (#16). (ii)

Attach the assembled 2ft cross supports to the perimeter frame with four hex bolts (#15), eight

washers (#9), and four lock nuts (#16)

(i) Begin at the side ends of the Wall Mounted Shelves and slide the 2ft Finishing Grid Section with

bent edges (#11) . The bent edges would slide below the installed Pulley & Cables. (ii) Place 2ft “U”

Shaped Grid Supports under wire grid (#13).