How to Guide

8
www.newageproducts.com
Installing Backsplash with Mobile System
Ensure that the Mobile Bottom is
tight against the wall and the top
of the worktop. Pre-drill 3mm (1/8”)
holes into each stud then fasten
Mobile Bottom Strip with screws
provided.
Align the side ends of the
slatwall with the side ends of the
worktop
Interlock bottom of Slatwall Section
with the top of Mobile Bottom and
follow steps 5 to 8 on page 7.
Remove protective adhesive
lm on the back of Mobile Side
Covers. Press rmly to adhere to
the wall.
• Follow steps 4 to 8.
• Drill pilot holes through the perforated
strip each 16in with hammer drill &
masonry bit.
• Use 2¼” x ¼” Tapcon Concrete Anchor
for each pilot hole. (Not Included)
• OR use #10 x 2” Screw with ⁄” masonry
plug for each pilot hole. (Not Included)
Masonry.
4
5
7
6
8