Installation Guide

ManualsBrandsNewAge Products ManualsOutdoors90° Corner Outdoor Kitchen Cover in Gray for Stainless Steel Classic or Aluminum Slate Cabinets

OUTDOOR KITCHEN 90 Degree Shelf Cover

Warning: Dispose of Polybag immediately

Do not leave children unattended near cabinets.

For assistance, call 1.877.306.8930; for UK 0800.031.4069; e-mail at info@newageproducts.com

65826-INSTL-01-Rev.01

Summary of content (7 pages)

PAGE 1
OUTDOOR KITCHEN 90 Degree Shelf Cover Warning: Dispose of Polybag immediately Do not leave children unattended near cabinets. For assistance, call 1.877.306.8930; for UK 0800.031.4069; e-mail at info@newageproducts.com 65826-INSTL-01-Rev.
PAGE 2
Manufacturer Warranty Limited Lifetime When this product is installed, operated and maintained according to the instructions attached to or furnished with the product, NewAge Products Inc. will replace the defective product or parts if the part fails as a result of defective materials or workmanship for the Lifetime of the product. NEWAGE PRODUCTS INC. WILL NOT PAY FOR: 1. Service calls to correct the installation of any NewAge products or to instruct you how to use or install them. 2. 3.
PAGE 3
2 3 Make sure that the velcro is on the left side of the cabinet Slide Cover to the left to align with side of cabinet.
PAGE 4
3 4 Locate 1 hook on front bottom flap. Repeat this process for all of the 4 hooks on the Pull down on hook by stretching elastic strap front and rear lower flaps. place hook under kick edge and rotate 90 degrees to engage on kick frame.
PAGE 5
* Optional Side Panels Installation 1 2 Remove Right and Left side panel covers from poly bag. Locate Right panel (loop tape above cover surface) on right side. Locate Left Side panel ( Hook tape on underside of panel.) Left Side Installation; Align top band velcro hook of left side panel with cabinet’s left side exposed velcro loop seam . Continue aligning and fastening front and back upright seams.
PAGE 6
* Optional Connecting Panels Installation 1 Overlay Velcro seam (hook) of left cabinet cover on top of right cabinet cover (loop) seam. Continue to attach Velcro seams together on front and back of covers.
PAGE 7
Care and Maintenance of your Polyester Covers Perform Regular Maintenance List of common conditions that cause discoloration of polyester Covers and should be avoided: 1. Chloride containing cleansers --- this includes bleach and any cleaners containing bleach 2. Muriatic acid (hydrochloric acid) --- commonly used to clean up after tile/concrete installation 3. Concentrated soap residue --- chemical additives will cause discoloration and some driedsoaps actually look like soil 4.