Installation Guide

52
Replacing Halogen Lightbulbs
To replace the halogen bulb in your grill you must rst remove the lens from the light housing. To
remove the lens from the housing, remove the Philips screw securing the housing in place. Snap the
lens out of the housing (including the metal bracket). Reach in using your ngers only, grip the two
outside edges of the light bulb, do not grip the top or bottom of the bulb, as it might break. Insert
the new bulb using your clean cloth and gently snap it into position.
Begin by unplugging the grill from the
power supply. Remove the screw holding
the light housing to the grill using a #2
Phillips screwdriver.
1
Carefully pull the housing out from grill,
it will be attached by electrical wire so do
not pull hard. Remove the clip holding the
light cover to the main light housing.
2
With the light cover removed pull the
halogen bulb out from light socket.
3
Replace bulb by pushing straight into light
socket. Re-attach light cover, and
re-install housing repeating steps 2. and 3.
in reverse order.
4
A
100w/12V
NOTE
• Disconnect grill at power source before replacing lightbulbs
• The oil from your ngertips will reduce the life of the bulb. It is recommended to touch the bulb
as little as possible and to wipe the bulb with a cloth after handling with bare ngers.