Use and Care Manual

6
hp://www.NewAir.com
ELECTRICAL CIRCUIT D IAGRAM
INSTALLATION
Before connecng the appliance to a power source, let it stand
upright for approximately 2 hours. This will reduce the possibility
of a malfuncon in the cooling system from handling during
transportaon.
Before operang your cooler for the first me, follow these steps:
Remove the exterior and interior packing.
Clean the interior surface of the unit with lukewarm water and a so cloth.
Place the cooler on a level surface that will be strong enough to support the
unit when it is fully loaded. To level your cooler, ad
just the front feet located
at the boom of the unit.
FAN3FAN2
FAN1
LIGHT
SERNSOR
PLUG
TRANSFORMER
COMPRESSOR
DISPLAY PCB
CONTROL PCB
MMMM
θ
θ