AF-1000 Series Evaporative Cooler OWNERS MANUAL Read and save these instructions. .
A Name You Can Trust Trust has to be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Introduction ......................................................................................................... 3 Safety Information & Warnings ........................................................................... 4 Parts List ............................................................................................................... 5 Use & Operation .......................................................................................
SAFETY INFORMATION & WARNINGS When using any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips: Carefully read all instructions before use. Check the condition of the unit after taking it out of the box. Ensure that all parts are in good condition.
PARTS LIST 1. 2. 3. 4. 5. 6. 7. Control Panel Air Louvers Carrying Handles Cord Wrap Honeycomb Filter Partition Carbon Filter 8. 9. 10. 11. 12. 13.
USE & OPERATION 1. 2. 3. 4. 5. 6. POWER: Connect the cord to a power outlet. An indicator light will turn on, indicating that the power source is connected. Press the “On/Speed” button to turn the unit on. When it turns on, the cooler will start at medium speed (number 2) and then drop to the low speed setting (number 1) after a few seconds. SPEED: To adjust the fan speed, press the “On/Speed” button repeatedly until the desires speed appears on the display.
INSTALLING FILTERS 1. 2. 3. 4. Remove the two included filters from their packaging. Unscrew the rear screen and install the two filters so that they are nearest to the rear screen, not the front of the unit. The order the filters are installed does not matter. Close the rear screen and screw it back in. Add water as mentioned in the previous section and your evaporative cooler is now ready to use. CLEANING & MAINTENANCE 1. 2. 3. 4.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE(S) POSSIBLE SOLUTION a. The power cord is not plugged in. b. The water tank is not locked into the unit. a. There is insufficient water in the tank. a. b. The cool button was not pressed. The pump is defective. b. There is no airflow. The unit does not cool at all. c. a. b. c. Check to make sure the plug is plugged into an outlet. The unit should beep twice once the power supply is connected.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.