Use and Care Guide

A NAME YOU CAN COUNT ON

INSTALLING FILTERS

1. Remove the two included filters from their packaging.

2. Unscrew the rear screen and install the two filters so that they are

nearest to the rear screen, not the front of the unit. The order the

filters are installed does not matter.

3. Close the rear screen and screw it back in.

4. Add water as mentioned in the previous section and your evaporative

cooler is now ready to use.

CLEANING & MAINTENANCE

1. Before disassembling the unit, unplug the unit from the power outlet

and drain all of the water from the tank by removing the drain cap.

2. Use a clean, damp cloth to wipe away any dust or dirt from the unit’s

exterior. Also wipe down the air louvers.

3. CLEANING THE DUST FILTER: Clean the dust filter by unscrewing

/pulling out the dust filter and washing the dust filter with running

water.

4. CLEANING THE HONEYCOMB FILTER AND TANK: Clean the

honeycomb filter and tank by following these steps:

 Unscrew and pull out the dust filter.

 Clean the honeycomb filter by using a vacuum or brush.

 Use a damp cloth with soap to clean and remove any residue from the

water tank.

 Rinse and drain the water tank.

 Replace the honeycomb and dust filters back into the unit. Make sure

the filters are properly inserted before tightening the screws.

NOTE: We recommend cleaning the unit every 3 months with regular use.

However, if you have hard water with a high mineral content, we recommend

cleaning the unit once a month to prevent residue buildup.