AI-215 Series Portable Ice Maker OWNERS MANUAL Read and save these instructions. . Manual v1.
A Name You Can Trust Trust should be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
REGISTER YOUR PRODUCT ONLINE Register Your NewAir Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up to date for safety, system updates and recall notifications Special Promotions Opt-in for NewAir promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: Register.NewAir.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Safety Information & Warnings ........................................................................... 5 Parts List ............................................................................................................... 6 Basic Parts Diagram ..................................................................................... 6 Control Panel Diagram .................................................................................
SAFETY INFORMATION & WARNINGS As with any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips: • • • • • • • • • • • Do not operate this appliance if it has a damaged cord. Only connect the ice maker to a properly polarized outlet. No other appliance should be plugged into the same outlet.
Do not touch the evaporator while the unit is in use or during the ice making process. It may cause severe burning. PARTS LIST BASIC PARTS DIAGRAM 1 4 6 7 5 2 3 http://www.NewAir.com 1. Cover 2. Control Panel 3. Water Drain Cap 4. Ice Basket 5. Ice Scoop 6. Ice Shovel 7.
FULL PARTS DIAGRAM
WIRING DIAGRAM CONTROL PANEL DIAGRAM BUTTONS: ON/OFF – Use to start or stop the unit SELECT - Selects ice size TIMER – Set or cancel timer (refer to page 9) http://www.NewAir.
CLEAN – Begin self-cleaning function (refer to page 7) LCD DISPLAY SYMBOLS: Power indicator Ice Bucket Full Indicator Ice size selected (small, medium or large) Add Water Indicator (flashes when water needs to be added) Timer display Warning Indicator – problem with unit Self-Cleaning Indicator ASSEMBLY & INSTALLATION 1. Remove the exterior and interior packaging. Check that the ice basket and ice scoop are included. If any parts are missing, please contact customer service. 2.
NOTICE: After unpacking your ice maker, it must rest in an upright position for at least two hours before you plug it in or the compressor may be damaged, shortening the life span of the unit. 5. Plug your appliance into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed to a certified electrician.
stop and the “Add Water” indictor light will flash in the LCD display window. Press the “POWER” button to stop the unit and unplug it. Fill the reservoir with water up to the level mark. Plug it in and press the “POWER” button again to restart the unit. Allow at least 3 minutes for the refrigerant inside the compressor to settle before restarting. 7. The ice maker automatically stops working when the ice basket is full. The “Ice Bucket Full” indicator will also turn on at this time. 8.
1. 2. 3. Press the TIMER button on the control panel. “1.0H” will flash in the Timer Set Display Window. Press the SELECT button to set the Timer delay to a time between 1.0 and 18.0 hours, in half hour increments. After the desired time is set, the display will show the time remaining and will decrease in 0.1 hour increments. When the timer reaches ZERO and disappears, the unit will stop running automatically.
8. 9. Dry the interior and exterior with a soft cloth. Tighten the drain cap. Replace the ice basket and plug the unit in again. To remove the build-up of calcium or other impurities, add a capful of vinegar or lemon juice to the water in the reservoir and run for two or three ice-making cycles. Drain and refill the reservoir with clean, warm water. Run two more cycles to rinse the vinegar or lemon-juice. When the machine is not in use open the water drain cap to completely drain the water reservoir.
Problem The “WARNING” indicator flashes for 20 seconds when starting or during operation. Ice cubes stick together. Possible Cause Ice-full detecting sensor on the edge of interior tank is malfunctioning. The ice cycle is too long. Water temperature in inner tank is too low. The ice making cycle appears to be normal but no ice is being produced. The ice cubes are too small. The ice has a “plastic” taste. The refrigerant may be leaking. A pipe in the cooling system may be blocked.
Problem The unit produces a large block of ice instead of cubes. Possible Cause The ambient temperature may be too low. The ice cubes have a cloudy appearance. There may be trace minerals in your water or ice is being produced too quickly. Solution Unplug the unit and let the ice thaw out. Allow the ice maker to defrost for a few hours and restart the unit. Ice cubes may develop cloudiness when water is frozen quickly.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
