User Manual

11
stop and the “Add Water” indictor light will flash in the LCD display
window. Press the “POWER” button to stop the unit and unplug it. Fill the
reservoir with water up to the level mark. Plug it in and press the “POWER”
button again to restart the unit. Allow at least 3 minutes for the
refrigerant inside the compressor to settle before restarting.
7. The ice maker automatically stops working when the ice basket is full. The
“Ice Bucket Full” indicator will also turn on at this time.
8. Change the water in the reservoir every 24 hours to ensure hygienic ice. If
the ice maker will not be used for an extended period of time, drain the
water from the reservoir by unplugging the drain off cap located on the
side of the ice maker.
USING THE TIMER
How to Set the ON-TIMER Program
When the unit is off, you can program the timer to start the unit after a set
number of hours.
1. Press the TIMER button on the control panel. “1.0H” will flash in the
Timer Set Display Window.
2. Press the SELECT button to set the Timer delay to a time between 1.0
and 18.0 hours, in half hour increments.
3. After the desired time is set, the display will show the time remaining
and will decrease in 0.1 hour increments. When the timer reaches
ZERO and disappears, the unit will start to run automatically according
to your settings.
To cancel when the time is set but not yet running, press the TIMER button
twice to cancel it.
How to Set the OFF-TIMER Program
When the unit is on, program the OFF-TIMER to stop the unit after a set time.