SKU: AI-215SS AI-215R Portable Countertop Ice Maker OWNER’S MANUAL Read and save these instructions. Manual v1.
REGISTER YOUR PRODUCT ONLINE Register Your NewAir Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up to date for safety, system updates and recall notifications Special Promotions Opt-in for NewAir promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: newair.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Safety Information & Warnings ........................................................................... 4 Parts List ............................................................................................................... 5 Assembly & Installation ....................................................................................... 7 Operating Instructions .......................................................................................
SAFETY INFORMATION & WARNINGS As with any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips: • • • • • • • • • • • Do not operate this appliance if it has a damaged cord. Only connect the ice maker to a properly polarized outlet. No other appliance should be plugged into the same outlet.
PARTS LIST BASIC PARTS DIAGRAM 1 4 6 7 5 2 3 1. Cover 2. Control Panel 3. Water Drain Cap 4. Ice Basket 5. Ice Scoop 6. Ice Shovel 7.
CONTROL PANEL DIAGRAM BUTTONS: ON/OFF – Use to start or stop the unit SELECT - Selects ice size TIMER – Set or cancel timer (refer to page 9) CLEAN – Begin self-cleaning function (refer to page 7) LCD DISPLAY SYMBOLS: Power indicator Ice Bucket Full Indicator Ice size selected (small, medium or large) Add Water Indicator (flashes when water needs to be added) Timer display Warning Indicator – problem with unit Self-Cleaning Indicator newair.
ASSEMBLY & INSTALLATION 1. Remove the exterior and interior packaging. Check that the ice basket and ice scoop are included. If any parts are missing, please contact customer service. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it. 3. Place your ice maker in a location that is protected from direct sunlight and other heat sources (e.g., stove, furnace, and radiator).
OPERATING INSTRUCTIONS MAKING ICE 1. Open the unit’s cover, remove the ice basket, and pour water into the water reservoir. Keep the water level below the “MAX” line marked inside the reservoir. 2. Plug in the unit to the grounded power supply outlet. 3. Press the “ON/OFF” button on the control panel to begin the ice making cycle. 4. Select the size of the ice cube by pressing the “SELECT” button.
USING THE TIMER How to Set the ON-TIMER Program When the unit is off, you can program the timer to start the unit after a set number of hours. 1. 2. 3. Press the TIMER button on the control panel. “1.0H” will flash in the Timer Set Display Window. Press the SELECT button to set the Timer delay to a time between 1.0 and 18.0 hours, in half hour increments. After the desired time is set, the display will show the time remaining and will decrease in 0.1 hour increments.
CLEANING & MAINTENANCE Clean the outside of the ice maker with a mild detergent solution and warm water. Use a soft cloth to wipe to avoid scratching or damaging the surface of the unit. Use the unit’s self-clean function to clean the interior of the unit: 1. Remove the ice basket. 2. Add 1:1 mixture of water and vinegar. 3. Plug in the unit. Hold down the CLEAN button for at least 6 seconds and release. The unit will automatically enter the self-clean program.
TROUBLESHOOTING Problem The “ADD WATER” indicator light is on. Possible Cause There is not enough water in the tank. The “ICE BUCKET FULL” indicator light is on. The “WARNING” indicator light is on. The ice basket is full. The “WARNING” indicator flashes for 20 seconds when starting or during operation. Ice cubes stick together. Ice-full detecting sensor on the edge of interior tank is malfunctioning. The ice cycle is too long. Ice shovel cannot rotate. Water temperature in inner tank is too low.
Problem The ice cubes are too small. Possible Cause The ambient temperature or water temperature may be too high. The compressor may need to warm up. The ice has a “plastic” taste. The unit’s interior may need to be cleaned. The unit produces a large block of ice instead of cubes. The ambient temperature may be too low. The ice cubes have a cloudy appearance. There may be trace minerals in your water or ice is being produced too quickly. newair.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.