SKU: AWB-360DB 24” Built-In Dual Zone Wine and Beverage Fridge OWNER’S MANUAL Read and save these instructions. . Manual v1.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Register Your Product Online ............................................................................... 3 Safety Information & Warnings ........................................................................... 4 Parts List ............................................................................................................... 5 Assembly Instructions ..........................................................................................
REGISTER YOUR PRODUCT ONLINE Register Your NewAir Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up to date for safety, system updates and recall notifications Special Promotions Opt-in for NewAir promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: newair.
SAFETY INFORMATION & WARNINGS Before Using Your Wine And Beverage Cooler for the First Time: Carefully read all instructions before using this wine and beverage cooler for the first time. Also make sure the wine and beverage cooler stays in an upright position during transportation. After removing the appliance from its packaging, make sure it is in good condition, and let the fridge stand for 24 hours before connecting to power, to allow refrigerant to settle.
PARTS LIST
ASSEMBLY INSTRUCTIONS INITIAL SETUP Remove exterior and interior packing materials and let the fridge stand for 24 hours before connecting to power, to allow refrigerant to settle. Once it is plugged in, let it run for at least 30 minutes before stocking. Do not change the temperature or adjust any settings during this time. INSTALLATION OF YOUR APPLIANCE • • • • • • • • • Use two or more people to move and install the appliance. Failure to do so can result in back or other injury.
NOTE: Designed for indoor, home use only. The appliance should not be located next to sources of high heat or in direct sunlight. Do not store or install the appliance outdoors, in a garage, basement or in moist areas. Don’t install in a location where the temperature will fall below 60℉. For best performance and to ensure proper ventilation, do not install the appliance behind a cabinet door or block the base grille.
OPERATING INSTRUCTIONS Power Powers on/off the appliance. To turn off the appliance, touch the hold 5 seconds. mark and Light To control the interior light to turn on/off. Up Used to increase the corresponding zone set temperature by 1℃ or 1℉. Down Used to decrease the corresponding zone set temperature by 1℃ or 1℉. ℃/℉ Selector Selects the temperature display setting to display in Fahrenheit or Celsius.
• • To view the set temperature at any time, touch the UP or DOWN marks. The set temperature will temporarily flash in the LED display for 5 seconds. The internal storage temperature will appear in blue on the temperature display window. NOTE: If the unit is unplugged, turned off, or power is lost, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay the unit will not start.
SHELVES To prevent damaging the door gasket, make sure to have the door completely opened when pulling the shelves out of the rail compartment. • • • • • • • • For easy access to the storage content, you must pull the shelf out of the rail compartment; however this unit was designed with a plastic post on each side of the shelf track to prevent bottles from falling. When removing the shelf out of the inner rail, make sure to remove all items first.
CLEANING & MAINTENANCE • • • • Shut off the power supply before cleaning the unit’s cabinet. Remove all cans and storage shelves. Clean the unit’s interior with a warm water and neutral detergent solution. Thoroughly dry all surfaces. Please Note: a. b. c. Do not use abrasive cleaners to clean the wine and beverage cooler. Use mild, soapy water to clean the unit’s door seal. To ensure efficient operation, also thoroughly clean the back and bottom of the wine and beverage cooler.
TROUBLESHOOTING Problem Possible Causes Solution The wine and beverage cooler does not cool. The unit may be plugged in using a different voltage. Check if using the wrong voltage. The circuit breaker may be tripped or there is a blown fuse. The unit may be placed too close to a heat source. Reset the circuit breaker or check for a broken fuse. There is insufficient ventilation. The door is not completely closed or the door seal is not working properly.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
