User Manual

9
CONTROL PANEL USE
When the unit is first turned on with the On/Off button, it will
beep twice, the air outlet will rotate from the current angle to 0°,
and the system enters the standby state. If there is no button
operation within 1 minute, the indicator light will darken. If the
button is pressed again, the indicator light will turn back to full
brightness.
The unit can be operated by pressing the button on the control
panel. The instructions are as follows:
ON/OFF CONTROL
Press the “On/Off” button for the first time to enter the
normal fan speed—this will cause the air outlet to
automatically rotate out toward the front. Press the
“On/Off” button again to shut down—this will cause the fan to
stop running and hide the air outlet. At this point, the fan is in
standby mode. To completely turn off the fan, press the On/Off
button.
Note: In order to extend the life of the product, it is
recommended to completely power off the product after each
use
TIMER
Press the “Timer” button to select 1 hour, 2 hours, 4
hours or 8 hours. If the LED is off, it means that the timer
function is not set. After selecting the time, the LED
indicator will display the set time and will automatically shut
down after the selected time has elapsed.
COOLER/HUMIDIFIER
Press the “Cooler/Humidifier” button to enable the water pump.
If the water pump is running, water will flow down through the
cooling pad and offer cooler air than the fan-only setting.