Owners Manual

newair.com

OPERATING INSTRUCTIONS

Note: When using the heater for the first time, you may notice a slight emission

of smoke. This is normal and will stop after a short time. The heating element is

made of steel and was coated with a layer of protective oil during production.

Setting Function

OFF

FAN ONLY

HALF HEAT

FULL HEAT

1. Position the heater so that it stands on a firm, level surface and at a safe

distance from any liquids or flammable materials.

2. Connect the heater to the proper electrical outlet. See grounding

instructions above.

3. Turn the setting knob to the desired position.

4. Use the MIN/MAX knob to set your target ambient temperature. Set the

knob to MAX, then once the room reaches your desired level of warmth,

slowly turn the temperature knob back until you hear a click and the

heating element shuts off (it may take a couple minutes for the heating

element to cool down). The heater will then maintain the current ambient

temperature. To increase or decrease the ambient temperature further,

turn the temperature knob toward MIN or MAX from where you set it.

Electrical outlet wiring must comply with local building codes and other

applicable regulations to reduce the risk of fire, electrical shock, and injury to

persons.

Do not use this appliance if any part of it has been exposed to water or other

liquids. Immediately contact customer service if your unit has been exposed

to water or other liquids.