NWC043SS00 43 Bottle Dual Zone Wine Cooler OWNERS MANUAL Read and save these instructions. Manual v1.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Register Your Product Online ............................................................................... 3 Safety Information & Warnings ........................................................................... 4 Parts List............................................................................................................... 7 Assembly & Installation .......................................................................................
REGISTER YOUR PRODUCT ONLINE Register Your NewAir Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up to date for safety, system updates and recall notifications Special Promotions Opt-in for NewAir promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: newair.
SAFETY INFORMATION & WARNINGS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others.
sure the power line of the unit is disconnected. • Do not connect or disconnect the electric plug when your hands are wet. • Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can result in electrical shock or death. • Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.
• The appliance should not be located next to ovens, grills or other sources of high heat. • The appliance must be installed with all electrical, water and drain connections in accordance with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in accordance with the National Electrical Code and local codes and ordinances is required. • Do not kink or pinch the power supply cord of appliance. • The fuse (or circuit breaker) size should be 15 amperes.
PARTS LIST newair.
ASSEMBLY & INSTALLATION BEFORE USING YOUR APPLIANCE • • • Remove the exterior and interior packing. Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth. INSTALLATION OF YOUR APPLIANCE • • • • • • • • The appliance is designed for free-standing installation only.
ELECTRICAL CONNECTION WARNING Improper use of the grounded plug can result in electrical shock. If the power cord is damaged, contact customer service immediately at support@newair.com. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
OPERATING INSTRUCTIONS It is recommended you install the appliance in a place where the ambient temperature is between 64° and 100°F (18°-38°C). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The range of 41-64°F (5-18°C) may not be reached.
NOTE: • If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the unit will not start. • When you use the unit for the first time or restart the unit after it has been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and is due to the length of the activation time.
CLEANING & MAINTENANCE CLEANING YOUR APPLIANCE • Turn off the power, unplug the appliance, and remove all items, including shelves. • Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). • Wash the shelves with a mild detergent solution. • Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts.
ENERGY-SAVING TIPS • The appliance should be located in the coolest area of the room, away from heat producing appliances and out of direct sunlight. • Ensure that the unit is adequately ventilated. • Do not keep the door open any longer than necessary. CAUTION: Failure to unplug the appliance during cleaning could result in electrical shock or other personal injury. newair.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service technician. Problem Possible Causes and Solution Appliance is not running • • • • Appliance is not cold enough • Check the temperature control setting. • Check if ambient temperature is beyond appliance operating temperature. • The door is opened too frequently. • The door is not closed properly.
Problem The door does not close properly Possible Causes and Solution • The appliance is not level. • The door seal is dirty or damaged. • The shelves are not positioned correctly. • A part of the contents is preventing the door from closing. newair.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
