WCD-100W Hot and Cold Designer Water Dispenser OWNERS MANUAL Read and save these instructions. .
A Name You Can Trust Trust has to be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Safety Information & Warnings ................................................................................3 Safe Operation Guidelines ...................................................................................3 Disposal Guidelines ..............................................................................................4 Parts List ..........................................................................................................
ALWAYS DO THIS: NEVER DO THIS: Always transport your water dispenser in a vertical position and stand on a stable, level surface during use. Keep the water dispenser out of direct sunlight. Keep a distance of at least 6” (15 cm) from walls on all sides of the water dispenser. If the water dispenser is knocked over during use, turn off the unit and unplug it from the power supply immediately. Keep ventilation openings clear of obstructions.
PARTS LIST PARTS DIAGRAM 1. Water guard 2. Cold tap (blue) 3. Warm tap (white) 4. Hot tap (red) 5. Drip tray 6. Storage cabinet 7. Cold switch (green) 8. Hot switch (red) 9. Refrigerating controller 10. Radiator 11. Drain plug 12. Power cord sets INSTALLATION & SETUP Before connecting the water dispenser to a power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
IMPORTANT: Customers are not meant to adjust the temperature by themselves by removing the sticker or screw at the back of the appliance. Doing so will void the warranty if product issues are found to be caused by such adjustments. TEMPERATURE ADJUSTMENT To adjust the water temperature on the unit, locate the white plug on the left side of the unit. Remove the plug to expose an area where you can use a flat tip to adjust the water temperature for both hot and cold.
4. Once the unit has been completely flushed, you can replace the bottle and restart the unit according to the instructions above. CAUTION: To avoid burns, avoid direct contact with the hot water. Never allow children to dispense hot water without supervision. CLEANING & MAINTENANCE CLEANING THE HOUSING Use a soft, damp cloth to wipe the body clean. Clean the drip tray and storage cabinet as needed. Remove dust from the condenser coils on the back of the unit to improve efficiency.
TROUBLESHOOTING Problem No water from the faucets. Does not provide hot or cold water. Electrical leakage. Loud noise. Water leakage. Possible Causes Air entrance has been blocked Solution Take down the bottle and reassemble it. Too much water has been used in a short time. Electric connection is loose. Wait for a while and try again. The connection is not good. Uneven footing. The bottle is broken. Make sure the switch is ON and the plug is in the socket. Make sure the plug is properly grounded.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.