WCD-110SS Water Dispenser OWNERS MANUAL Read and save these instructions. .
A Name You Can Trust Trust has to be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Safety Information & Warnings ................................................................................4 Safe Operation Guidelines ...................................................................................4 Disposal Guidelines ..............................................................................................4 Parts List ..........................................................................................................
SAFETY INFORMATION & WARNINGS SAFE OPERATION GUIDELINES To reduce the risk of fire, electrical shock and/or injury to persons or property please follow basic safety precautions. Be sure to read all instructions before using this appliance and observe the following safety tips: ALWAYS DO THIS: NEVER DO THIS: Always transport your water dispenser in a vertical position and stand on a stable, level surface during use. Keep the water dispenser out of direct sunlight.
As old products contain valuable resources, they can be sold to scrap metal dealers. PARTS LIST PARTS DIAGRAM 1. Water intake (water bottle sits here) 2. Hot water valve (with safety switch) 3. Cold water valve (with safety switch) 4. Removable drip tray 5. Cooling switch (green) 6. Heating switch (red) 7. Cooling thermostat 8. Condenser 9. Hot/cold water drain 10. Power cord INSTALLATION & SETUP Before connecting the water dispenser to a power source, let it stand upright for approximately 2 hours.
button before pressing in the dispensing button. IMPORTANT: Customers are not meant to adjust the temperature by themselves by removing the sticker or screw at the back of the appliance. Doing so will void the warranty if product issues are found to be caused by such adjustments. TEMPERATURE ADJUSTMENT To adjust the water temperature on the unit, locate the white plug on the left side of the unit.
3. Run all taps until they are empty, then open the drain plug on the back of the unit and drain the remaining water from the dispenser into a bucket or other container. 4. Once the unit has been completely flushed, you can replace the bottle and restart the unit according to the instructions above. CAUTION: To avoid burns, avoid direct contact with the hot water. Never allow children to dispense hot water without supervision.
TROUBLESHOOTING Problem No water from the faucets. Does not provide hot or cold water. Electrical leakage. Loud noise. Water leakage. Possible Causes Air entrance has been blocked Solution Take down the bottle and reassemble it. Too much water has been used in a short time. Electric connection is loose. Wait for 5 minutes and try again. The connection is not good. Uneven footing. The bottle is broken. Make sure the switch is ON and the plug is in the socket.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.