Instructions / Assembly

5
A Name You Can Trust
 As old products contain valuable resources, they can be sold to scrap metal dealers.
PARTS LIST
PARTS DIAGRAM
INSTALLATION & SETUP
Before connecting the water dispenser to a power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
LOCATION
 The water dispenser should be placed on a firm, even foundation to minimize
noise and vibration.
 Do not place the dispenser in direct sunlight or near other heat producing
appliances.
 To avoid accidental water damage, locate it away from furniture or other
appliances.
 The unit must be placed within reach of a properly rated grounded socket.
 Never place any obstacles around the air inlet or outlet of the unit.
 Allow a minimum 6-inch clearance on all sides for efficient operation.
OPERATION
To dispense hot water, push up the button that is above the hot water dispensing
1. Water intake (water bottle sits here)
2. Hot water valve (with safety switch)
3. Cold water valve (with safety switch)
4. Removable drip tray
5. Cooling switch (green)
6. Heating switch (red)
7. Cooling thermostat
8. Condenser
9. Hot/cold water drain
10. Power cord