Operation Manual SIB 16x40 GR BINOCULARS WITH IMAGE STABILIZATION NEWCON 2002© Printed in Canada In USA: 3310 Prospect Ave. Cleveland, OH 44115 In Canada: 1183 Finch Ave. W.
IMPORTANT INFORMATION Read prior to activation You have just purchased a complicated electronic device. To operate it properly, please read this manual carefully. Here are some common precautions that must be noted. 10. QUALITY CERTIFICATE The SIB 16x40 GR is suited for usage.
9. CUSTOMER SUPPORT Should you experience any difficulties with your Newcon OPTIK product, consult the enclosed manual. If the problem remains unresolved, contact our customer support department at (416) 663-6963 or Toll free at 1-877-398-6666. Our operating hours are 9am-5pm, Monday - Friday, Standard East Time. At no time should equipment be sent back to Newcon without following the instructions of our technical support department. Newcon accepts no responsibility for unauthorized returns.
BEFORE USE CAREFULLY READ ALL THE INSTRUCTIONS! FAILURE TO OBEY THE INSTRUCTIONS WILL VOID THE WARRANTY! 1.
7. TROUBLE SHOOTING 2. APPEARANCE OF THE DEVICE The stabilizing mode does not work. Check that the batteries are installed properly. Check the charge of the batteries. Replace if they are weak. Do not use old batteries with new ones. The image does not appear in focus. Bring the inspected object to the center of the image. Turning the eyepieces (8), adjust to achieve the clearest image on the screen. If the view still does not seem in focus, clean the lenses. They could be foggy or dusty.
. STORAGE AND MAINTENANCE INSTRUCTIONS. Warning! After transportation or keeping the device at temperature lower than –25°C (–13°F), the device must be warmed up to ambient temperature for at least 6 hours before operating. 1–cartridge with AA type batteries; 2–connector; 3–pin; 4–cramp; 5–delimiter; 6–lock Fig. 2 – Power Supply Unit The device is powered by either a cartridge with batteries (1) or by an on-board power source 12±1.2 V via connector (2).
. In no less than a minute, press lever 5 (fig. 1) in the arrow indicated direction in order to engage the stabilizing mode and hold it in this position while observing. ATTENTION! It is not allowed to engage the stabilizing mode of the device when the power supply control indicator is not glowing, or in less than a minute after device has been turned ON. When finishing the observation release lever 5 (fig. 1). The lever should return to the initial position.
4. SUPPLIED ACCESSORIES SIB 16x40 Gyro is supplied in the following assembly: - Device - Objective lens caps - Carrying Case - Neck Strap - Hand Strap - DC regulator - User’s manual - Warranty card Optional accessories: - Amber Filters (optional) - Night Vision eyepieces (optional) 1 pc. 2 pc. 1 pc. 1 pc. 1 pc. 1 pc. 1 pc. 1 pc. 2 pc. 2 pc. 5. OPERATION INSTRUCTIONS 5.1. Preparing the Device for Operation without Image Stabilization 1.
