User's Manual

Page 9Page 4

Troubleshooting

If the Link Status LED on the Wireless Module is amber, a wireless

connection cannot be made between the Wireless Module and the

USB Adapter. Please try the following steps to establish a wireless

connection between these two mimio Wireless components:

1. Ensure the PC is powered and turned on.

2. Ensure the USB Adapter is plugged into an available USB

port on your PC.

3. Ensure the mimio Xi is powered on and has a green power

LED. If the power LED is amber, replace the four AA

batteries in the mimio Xi capture bar.

4. Move the mimio Xi (with Wireless Module) closer to the

computer with the USB Adapter connected to it.

If you still cannot establish a wireless connection after following the

steps listed above, try unplugging the USB Adapter from the PC and

then reinserting in the USB Adapter into the PC. If this does not

help, then follow the steps outlined in the Learning Process section

to re-bind the Wireless Module and USB Adapter. If completing the

Learning Process does not result in a wireless connection, please

contact our Technical Support department using one of the contact

methods described in the Technical Support section.

Setup Process

Depress the release button and

slide the linkUSB module

downward to remove the module

from the mimio Xi.

Insert/slide the Wireless Module

into the mimio Xi.

Install the mimio software from

CD if not already installed. Check

our website for the latest mimio

software (www.mimio.com).

Wireless

3 8