User Manual

5
Wireless Network Setup
1. Peer-to-Peer: Connects with other wireless client(s). This does not require Access Point. Please
make sure the “Network Name” (SSID or ESSID) and “Peer-to-Peer” channel are the same for
all clients in the same wireless network. Double click on the Configuration Utility icon to open the
utility.
- Click on “Profile Setting” tab and “Add” to create a new profile.
- Enter a name that the profile correspond, click “Next”.
- Select the “Network Type”, click on the drop-down arrow and select “Peer-to-Peer”, and then at
“Peer-to-Peer Channel”, use the up/down arrows to select the channel number, and then click
“Next”.
- Select the Authentication Mode to enable the “Encryption” if you have any security concern.
Once you enable the encryption function, then you should input the corresponding key. Click
“Next”.
- On IP Setting select “Enable” or “Disable” to make used of it. Click
“Complete” to finish the configuration.
2. Access Point: Connects to network via Access Point.
- Click “AP List” tab.
- Select the listed Wireless Network to Join.
- Click “Connect” to join the network.
* Note: You might need to configure a Profile before if the destination network had a “WEP KEY”
protected.
The equipment has been tested and found to comply with FCC and CE Rules.Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may cause undesired operation.