User guide

nlscan.com
Page 107
Batch Programming
Itruducation
Batch Programming can integrate a programming sequence into one barcode.
Batch Programming Rules:
1. Sub-command is in this format: Programming Command + Parameters
2. Sub-commands are terminated by semicolons. Note that there is no blank between a sub-
command and its terminator semicolon.
3. “Save Programming”(0000160) to terminate
4. Use Barcode Generator software to make the 2D batch barcode.
For example, to generate a batch barcode for “Illumination Keep ON”(0200030), “Sensor
Mode”(0302010), “Sensor Mode Timeout = 2 seconds”(0313000), and “Disable Fixed Length
Selection”(0405140)for Interleaved 2 of 5.
0200030; 0302010; 0313000 = 2000; 0405140; 0000160; Generate a batch code.
Allow Read Batch Code
【Pro CMD：0001110】
Code Programming ON
Code Programming OFF
Tools