User's Guide

Enter Setup
** Exit Setup 52
End of Transmission Message for Batch Mode
You may scan the appropriate barcode below to select whether or not to send an end of transmission message
(user-programmable) to notify the host when transmission of all stored data is done.
** End of Transmission Message Off
End of Transmission Message On
An end of transmission message can contain up to 10 characters (HEX values from 0x00 to 0xFF). To set an end of
transmission message, scan the Set End of Transmission Message barcode, the numeric barcodes representing the
hexadecimal values of desired character(s) and the Save barcode. The default setting is “EOT”.
Set End of Transmission Message
Set the end of transmission message to “END” (HEX: 0x45, 0x4E, 0x44):
1. Scan the Enter Setup barcode.
2. Scan the Set End of Transmission Message barcode.
3. Scan the numeric barcodes “4”, “5”, “4”, “E”, “4” and “4” from the “Digit Barcodes” section in
Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.