User's Guide

Enter Setup
** Exit Setup 54
Retransmission
If the Transmission feature is on, the scanner awaits an ACK response from the host following a data packet transmission,
and resends the packet when it receives an NAK response or the retransmission timeout expires. Note that Data Packing
must be enabled for this feature to function (See the “Data Packing Options” in Chaper 9 to learn how to enable it).
** Retransmission Off
Retransmission On
Transmission Timeout
This specifies the amount of time the scanner waits for an ACK response from the host following a data packet
transmission. It is programmable in 1ms increments from 200ms to 10,000ms. The default value is 200ms. Note that the
Retransmission feature must be turned on for this to function.
Set Transmission Timeout
Set the transmission timeout to 300ms:
1. Scan the Enter Setup barcode.
2. Scan the Set Transmission Timeout barcode.
3. Scan the numeric barcodes “3”, “0” and “0” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.