User's Manual

—

Introduction

Congratulations on your purchase! Your new RF-Mouse is easy to install and offers you a host of useful features.

The Radio receiver can be conveniently placed to give you the freedom you need while working. The vertical

wheel allows you to scroll, or zoom in and out in a document. You can program the mouse buttons to launch the

NetJump or LuckyJump for a quick start to programs you run frequently. And, your RF-Mouse has a unique ID

code, so other RF (Radio Frequency) pointing devices won’t affect your system.

Connecting the RF-Mouse Receiver

The RF-Mouse receiver connects to your computer in the same way as a

conventional mouse allowing you to place the receiver wherever is convenient on

your desktop.

1. Locate the round 6-pin PS/2 mouse port on the back of your computer.

2. Insert the PS/2 connector into the PS/2 port.

Locating the RF-Mouse Receiver

Your RF-Mouse has limitations on the range or distance from the receiver. To make sure that your mouse

sends and receives properly, refer to the following:

1. For optimal performance, place the receiver at least 8 inches (20 centimeters) away from other

electrical devices, such as the computer, the monitor, or external storage drives.

2. The RF-Mouse should be no farther than 3.3 feet (1.0 meter) from the mouse receiver. This will

ensure optimal communication between the mouse and receiver.

3. If you are working on a metallic surface, try using a mouse pad and turning the receiver face down

for better reception.

4. Switch frequency channels to prevent interference from other RF pointing devices. (See the

following section for more information.)

Selecting the Frequency Channel

The RF-Mouse operates on two frequency channels.

To prevent interference when using two RF Mice in

close proximity a different frequency channel should

be used for each mouse. Refer to the following to

change the frequency channel for your mouse:

1. Set the frequency channel on the receiver to 1 or

2. Remove the battery cover from the mouse (see

the following Inserting the Batteries section).

3. Set the frequency channel on the mouse to 1 or

2. (The frequency channel for mouse and

receiver must be the same.)