ROMAN TUB 3 VALVE AND TRIM INSTALLATION INSTRUCTIONS Valve Model No`s Trim Kit for Model No's 1-570 3-2557 2001 CARNEGIE AVE, SANTA ANA CA 92705 (949) 417-5207 WWW.NEWPORTBRASS.
We recommended Installation of this product by a Professional Plumbing Contractor Note: Use plumbers tape or equivalent to seal all threaded joints. Warning: To prevent severe damage to valve body, any solder/braze process 3 must be performed a min. of 4" from ports. It is strongly recommended that an access panel(s) is built into the roman 2 bath surround. Access panels allow for ease of trim installation and future possible repairs.
Trim Installation Utilizing 3/4” copper pipe, make connections between spout, valves & water supply. See Figure 4. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. Apply thread sealant and insert a rubber WASHER (16) into each end of HOSE (15). Attach one end of HOSE (15) to diverter OUTLET (14). Pull other end through deck FLANGE (18) and attach to hand SHOWER (19). Place hand SHOWER (19) into deck FLANGE (18). See Figure 5.
Disclaimer Regarding Roman Tub with Hand Spray To conform to local codes and ordinances, all Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).