User Manual

11/16/2010
Trim Installation
Note:To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation
only.
(Cartridge Bonnet factory torque is 14-16 ft-lbs.)
4. Place O-RING and ESCUTCHEON over VALVE STEM. Secure handle assembly into place by first engaging
the VALVE STEM, then position and holding the handle LEVER while rotating the BONNET and
ESCUTCHEON. Any adjustments for rotational alignment must be made to the valve body, not to the
cartridge. See Fig. 3
5.Align and press spout assembly onto quick connect deck flange. Make sure spout is flush with deck. Secure
spout onto quick connect with setscrew. See Fig. 3
6.Turn on water supply, check for leaks and make any final adjustments required.
Figure 3
Spout
Assembly
O-ring
Deck Flange
Quick Connect
Set Screw
Handle Lever
Bonnet
Escutcheon
Stem
O-ring
Nipple Quick Connect