User guide

ManualsBrandsNewport Brass ManualsFor Home1-666

ROMAN TUB 3 VALVE AND TRIM

INSTALLATION INSTRUCTIONS

Valve Body No. 1-666

Trim Kit for Model No’s: 2047, 2047-1

Congratulations on the purchase

of this Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

2047-1

Hand Shower

Summary of content (5 pages)

PAGE 1
ROMAN TUB 3 VALVE AND TRIM INSTALLATION INSTRUCTIONS Valve Body No. 1-666 Trim Kit for Model No’s: 2047, 2047-1 2047-1 Hand Shower Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use Teflon tape or equivalent to seal all threaded joints. Plumb with 3/4” copper pipe is recommended. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the spout quick connect shank through spacer and appropriate hole of mounting surface. Secure with washer nut. 2. Place lower washer nut on valve body.
PAGE 3
Trim Installation Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 1. Thread Spout Nipple into base of spout. Attach spout base with mounting screws. Place o-ring on deck, around deck flange. Insert spout nipple into deck flange & secure into place with set screw. 2. Placeo-ring and escutcheon over valve stem.
PAGE 4
Disclaimer Regarding Brasstech Roman Tub with Hand Spray To conform to local codes and ordinances, all Brasstech Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).
PAGE 5
LIMITED WARRANTY Brasstech, Inc. warrants to the original consumer residential purchaser ("Original Purchaser") that if a product in its; Newport Brass ®, Brasstech ®, Motiv ®, Plumbtrim ® or GINGER® lines of products ("Product") is confirmed upon inspection to be defective in materials or workmanship during the warranty periods described below, Brasstech, Inc. will, at its option, either repair or replace the Product with a similar current model of the Product.