Manual

Single and Double Towel Bar / 2 & 3 Post Tissue Holder
Installation Instructions
Model No. 10-01, 10-02, 10-04, 10-09, 10-28
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. (See Fig. 1)
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 1/8"
· 24" Single Towel Bar - 24 1/8"
· 30" Single Towel Bar - 30 1/8"
· 18" Double Towel Bar - 18 5/8"
· 24" Double Towel Bar - 24 5/8"
· Tissue Holder (2 Post) - 6 1/4"
· Tissue Holder (3 Post) - 6 1/4" (2x), (See Fig. 2)
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Dis-assemble END POST (6) from POST (3). See Fig. 5. Remove ESCUTCHEON (5) from
POST (3). See Fig. 4. Loosen SETSCREW (4) in FLANGE (1) and remove POST (3). Fasten
FLANGE (1) to wall using either WOOD/TOGGLE SCREW (2). See Fig. 3.
4. Engage POST (3) into FLANGE (1). Position POST (3) height to 2 5/16“ from mounting sur -
face. Secure POST (3) into place with SETSCREW (4). See Fig. 3.
5. Thread ESCUTCHEON (5) onto POST (3). See Fig. 4.
6a. Towel Bars (Single): Assemble TOWEL BAR (7) between END POSTS (6). Slide END
POSTS (6) onto POST (3) and secure into place with SETSCREW (4). See Fig. 5.
6b. Towel Bars (Double): Take the finished towel bar assemble and place END
POSTS (6) onto POST (3). Secure into place with SETSCREW (4). See Fig. 6.
6c. Tissue Holder (2 & 3 Post): Place END POST (6) onto POST (3) and secure into place
with SETSCREW (4). Place HOLDER (8) between END POST (6). See Fig. 7.
Distance between
posts
Fig. 1
Fig. 2
Fig. 3
2
1
5
3
Fig. 4
Fig. 5
Fig. 7
6
4
6
4
8
6
6
3
Distance
between
posts
Distance
between
posts
3
3
3
2 5/16”
3
4
7
Fig. 6
3
4
6