Installation & Assembly

Adjust Handle Alignment:
1. In Figure 5, ensure cartridges in full closed position and check HANDLE alignment. If the
HANDLE is not correctly aligned, temporary remove the HANDLE, loosen up (but do not
completely remove) the ADAPTER SCREW and rotate CARTRIDGE ADAPTER one tooth
clockwise (18 degrees), reassemble the HANDLE and recheck alignment. Repeat until the
HANDLE is aligned.
2. Remove the HANDLE and tighten the ADAPTER SCREW to firmly secure the CARTRIDGE
ADAPTER to cartridge. Reassemble the HANDLE.
NWP-1400-5412
EN-3866
REV - A
05/31/2019
2001 CARNEGIE AVE, SANTA ANA CA 92705
[phone]
WWW.NEWPORTBRASS.COM
Figure 5
Handle
Adapter Screw
Adapter