NWP 2040 4261

NWP-2040-4261

REV - G

Installation Instructions

STEP 1:

Assembling

the

Tub Filler: Figure 3 illustrates the staggering technique required to thread the

two ¾” INLETS of the flexible SUPPLY LINES through the TUBING RISER.

a. Install FLANGE over the TUBING RISER.

b. Pass the staggered SUPPLY LINES through the TUBING RISER.

SUPPLY LINE

INLETS

TUBING RISER

FLANGE

Figure

Assembling

the

Tub

Filler

Note: Staggering tub filler inlet fittings will allow them to be threaded through the

base.

c. Attach the Tub Filler MAIN BODY to TUBING RISER.

i. With the SUPPLY LINES internal to the TUBING RISER, connect the MAIN BODY to the

TUBING RISER as follows depending on Model Number.

1.Model No. 2480-4261 and 2560-4261: Rotate the male threads of the TUBING

RISER into the female threads of the Tub Filler Main Body until snug.

2. Model No. 2040-4261:

Insert

TUBING RISER

into

Tub Filler Main Body and secure

with set screw located at the base of the MAIN BODY.

d. Secure the Spout into position by tightening the set screw located at the top of

the

Tub Filler

MAIN BODY.

STEP 2 (A or B)

When used with Brasstech Rough-in Kit 1-339

Unscrew the three PHILLIP HEAD SCREWS to remove the ALIGNMENT PLATE as shown in

Figure 4. Unscrew and discard the two PLUGS.