NWP 2040 4261

P-2040-4261

REV - G

Figure

Brasstech Rough-in Kit 1-339.

As shown In Figure 5, feed the Tub Filler Inlets through the ALIGNMENT PLATE. Use the 3

provided PHILLIP HEAD SCREWS to attach the Tub Filler Bottom Base to the ALIGNMENT

PLATE. Place the Tub Filler on the floor and connect the Tub Filler Inlets to the appropriate hot

and cold water supply of the Rough-in Kit. Ensure the Tub Filler handle is in off position, turn on

water supply to test water connections to confirm water tight seals. Hold the Tub Filler upright

and wind the Tub Filler flex hoses counter-clockwise and feed the flex hoses inside the ROUGH-

IN HOUSING. Orient the Tub Filler with its spout facing to the desired direction and re-attach

the ALIGNMENT PLATE to the ROUGH-IN HOUSING using the remaining 3 PHILLIP HEAD

SCREWS. Check for any water leaks again before sliding the BASE COVER down to cover the

Rough-in.

PHILLIP HEAD SCREW

ALLIGNMENT PLATE

PLUG