Installation Sheet

INSTALLATION INSTRUCTIONS

2-734

STABILIZER KIT

For Exposed Tub Floor Risers Kit

DRY WALL

ANCHOR

X 1

TILE

ANCHOR

#8 SCREW

WALL MOUNT

PLATE

5/64”

HEX KEY

STABILIZER

KIT

X 2

X 1

X 2

ITEMS INCLUDED

2001 CARNEGIE AVE, SANTA ANA, CA 92705

(949) 417-5207

WWW.NEWPORTBRASS.COM

NWP - 2-734

EN-1708

REV -

TOOLS REQUIRED

PHILLIPS

SCREW DRIVER

PEN / PENCIL

HAMMER

1/4”(6 mm)

DRILL

PAGE 1
TOOLS REQUIRED ITEMS INCLUDED DRY WALL ANCHOR TILE ANCHOR X2 PHILLIPS SCREW DRIVER INSTALLATION INSTRUCTIONS X2 PEN / PENCIL #8 SCREW 2-734 X2 1/4”(6 mm) DRILL WALL MOUNT PLATE STABILIZER KIT For Exposed Tub Floor Risers Kit X1 HAMMER 5/64” HEX KEY X1 X1 STABILIZER KIT 2001 CARNEGIE AVE, SANTA ANA, CA 92705 (949) 417-5207 WWW.NEWPORTBRASS.
PAGE 2
TUB OVERFLOW DRAIN MOUNT WALL MOUNT WALL MOUNT PLATE INSTALLATION 1. Loosen all set screws on the Stabilizer Kit 1. Loosen all set screws on the Stabilizer Kit 2. Adjust Stabilizer Rings to fit over Floor Risers and Tub Overflow Drain (See Figure 1) 2. Adjust Stabilizer Rings to fit over Floor Risers ( See Figure 2) 1. Unscrew to remove Tub Overflow Stabilizer Ring (See Figure 3a) 3. Attach Wall Mount Plate (See Figure 3a & 3b) 3. Tighten all set screws to secure the Stabilizer Kit to the Risers 4.