Installation Sheet

NWP-2152 6/20/09

SHOWERHEAD ASSEMBLY

INSTALLATION INSTRUCTIONS

MODEL NO. 2152, 2153

WWee rreeccoommmmeenndd IInnssttaallllaattiioonn ooff tthhiiss pprroodduucctt bbyy aa PPrrooffeessssiioonnaall PPlluummbbiinngg CCoonnttrraaccttoorr

NNoottee::

Regarding fittings, the use of petroleum based plumber’s putty on our products will nullify

the warranty. We recommend the use of clear silicone sealing materials as outlined by the

manufacturer.

To avoid damage to trim, all mating surfaces,(tile, paint, etc.), should be finished prior to trim instal-

lation.

Recommended trim for installation 517-xx, sold separately. Note: -xx designates various nipple

length available for installation requirements.

Shower Head Installation:

As noted above, installer must use an appropriate length 1/2” NPT nipple, not included, for prod-

uct installation.

1. Apply thread sealant to inlet end of NIPPLE (1a) and thread into FITTING (2) behind finished

ceiling.

2. Apply a small bead of clear silicone to backside of FLANGE (4), not included, and slide over

NIPPLE (1) and flush against ceiling.

3. Apply thread sealant to outlet end of NIPPLE (1b) and attach shower HEAD (3).

Note: Adjustment to shower head angle to accommodate wall mounted shower arm as follows:

loosen SHELL NUT (5), adjust angle of SHOWERHEAD (3). Re-tighten NUT (5) accordingly to ensure

proper seal.

Figure 1

Ø1-1/4 MODEL: 2152

Ø1-1/8 MODEL: 2153

Ø8-15/16 MODEL: 2152

Ø8-7/8 MODEL:2153

3-1/8

2-1/8

1/2-14 NPT

Shown with Nipple / Flange assembly: #517-8 (Sold separately)

PAGE 1
SHOWERHEAD ASSEMBLY INSTALLATION INSTRUCTIONS MODEL NO. 2152, 2153 We recommend Installation of this product by a Professional Plumbing Contractor Note: Regarding fittings, the use of petroleum based plumber’s putty on our products will nullify the warranty. We recommend the use of clear silicone sealing materials as outlined by the manufacturer. To avoid damage to trim, all mating surfaces,(tile, paint, etc.), should be finished prior to trim installation.
PAGE 2
LIMITED WARRANTY Brasstech, Inc. warrants to the original consumer residential purchaser ("Original Purchaser") that if a product in its; Newport Brass ®, Brasstech ®, Motiv ®, Plumbtrim ® or GINGER® lines of products ("Product") is confirmed upon inspection to be defective in materials or workmanship during the warranty periods described below, Brasstech, Inc. will, at its option, either repair or replace the Product with a similar current model of the Product.