User Manual

Towel Ring / Garment Hook
Installation Instructions
Model No. 24-09, 24-12
Recommended Installation by a Professional Contractor
1. Drill holes in wall at points marked using the appropriate drill size:
· Wood Screw (#10 x 1 3/4”) - use: 1/8" Drill
· Toggle Screw (10-24 x 3”) - use: 9/16" Drill
2. Loosen SETSCREW (4) in FLANGE (1) and remove POST (3). Fasten FLANGE (1) to
wall using either WOOD/TOGGLE SCREWS (2). (See Fig. 1)
Align FLANGE (1) so that upper flat is level.
3.Thread POST (3) onto FLANGE (1) Position POST (3) height to 2” from mounting sur
face. Secure POST (3) into place by tightening SETSCREW (4). (See Fig. 1)
4.Thread ESCUTCHEON (5) onto FLANGE POST (3). (See Fig. 2)
5a. Towel Ring: Slide END POST (6) onto FLANGE POST (3) and secure into place
with SETSCREW (4). (See Fig. 3)
5b. Garment Hook: Slide END POST (6) onto FLANGE POST (3) and secure into
place with SETSCREW (4). (See Fig. 4)
Fig. 1
[phone]
AMS-24-09 Santa Ana CA 92705 7/07/04
www.brasstech.com
Fig. 3
Fig. 4
6
4
4
3
2
Fig. 2
1
3
5
3
6
2”
3
4