Installation & Assembly

NWP-2470-5203
Figure 1
Figure 1a
1
3
2
1
Mounting
surface
hole
Recommended Installation by a Professional Plumbing Contractor
Note: The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend
the use of clear silicone sealing materials.
If mounting faucet to stainless steel rim, an under-mount support, (e.g. wood, appropriate size x 1/2”
thick), should be utilized.
1. Drill hole in mounting surface. Recommended deck hole Ø1.500”
not to exceed Ø1.562”.
2. Place O-ring (2) on underside of base RING (1). See Figure 1a.
3. Insert Hoses through base RING (1) and hole in mounting surface. Secure into place with MOUNTING KIT
(3). See Figure 1.
4. Attach hot/cold spout supply directly to valves in the wall. See Fig. 2
5. With faucet in the OFF position, open water supplies valves. Inspect connections under sink for leaks. DO
NOT turn faucet on yet.
6. Detach AERATOR ASSY (4) from SPOUT (5), turn on faucet and flush for one minute to remove debris from
lines.
7. Turn OFF faucet and reattach AERATOR ASSY (4) to SPOUT (5).
Figure 2
REV A
5
4
9/16-24 UNEF (FOR 3/8”
COMPRESSION OUTLET )
3/8” COMPRESSION
OUTLET )