Installation Guide

ManualsBrandsNewport Brass ManualsShop All Newport BrassNewport Brass Kiara Vertical Spray Double Handle Bidet Faucet with Metal Lever Handles

COMPLEMENT THIS PRODUCT WITH THESE

COORDINATING ACCESSORIES:

CIRCE

™

INSTALLATION INSTRUCTIONS

BIDET SET

sconce lights

•

mirrors

•

towel bars and rings

•

toiletry shelves and trays

toilet tissue holders

•

robe hooks

•

hotel shelves

•

grab bars

soap dishes and dispensers

•

tumblers

•

toothbrush holders

•

curtain rod holders

MODEL w/ CROSS HANDLE: G27-008

MODEL w/ LEVER HANDLE: G27-108

US D521,606 S. US D522,103 S. US D523,525 S.

Summary of content (4 pages)

PAGE 1
CIRCE ™ I N S TA L L AT I O N I N S T R U C T I O N S BIDET SET MODEL w/ CROSS HANDLE: G27-008 MODEL w/ LEVER HANDLE: G27-108 COMPLEMENT THIS PRODUCT WITH THESE COORDINATING ACCESSORIES: sconce lights • mirrors • towel bars and rings • toiletry shelves and trays toilet tissue holders • robe hooks • hotel shelves • grab bars soap dishes and dispensers • tumblers • toothbrush holders • curtain rod holders US D521,606 S. US D522,103 S. US D523,525 S.
PAGE 2
Installing Hot & Cold Valves The blue marked valve goes into the right side hole, the red marked valve goes into the left side hole. See Figure 1. Place flange NUT (1) and WASHER (2) on valve BODY (3). Insert valve BODY (3) from underside through hole in mounting surface at rear of bidet. Adjust valve height to approximately 1-5/16” above mounting surface. Using NUT (1) and WASHER (2) secure valve BODY (3) in place. See Figure 2.
PAGE 3
Installing Drain Components Remove drain PLUG (A) from FLANGE (B). A Place FLANGE (B) and white WASHER (C) through sink drain opening. (Clear silicone may be used in place of white washer.) From bottom side of sink, place cone shaped rubber WASHER B (D) onto FLANGE (B) and slide up against sink bottom. Note: Cone portion of WASHER (D) to face upward. Slide on clear flat WASHER (E) and secure with flange NUT (F). C Place clear WASHER (G) into drain BODY (H) and tighten to FLANGE (B).
PAGE 4
Ginger® Product Care Simple care is all that is needed in maintaining this product. Abrasive cleansers, detergents and silver or brass polish may result in damage to the finish and therefore should not be used. To clean, simply wipe with a soft, water-dampened cloth. Ginger hand, deck and wall shower sprays feature easy-cleaning jets. The jets should be cleaned periodically by rubbing your thumb or a damp cloth across the jets to loosen mineral deposits.