Installation Sheet

Trim Installation
Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation
only.
(Cartridge Bonnet factory torque is 14-16 ft-lbs.)
4.Attach handle trim to valve. When possible, any adjustments for rotational alignment should be made to the
valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to
prevent damage to the surface finish.) Secure handles into place with setscrew. See Fig. 3
5.Apply plumbers tape to spout nipple and install into base of spout. Slide spout nipple into quick connect
deck flange (re-grease if necessary). Make sure spout is flush with deck and secure into place with setscrew.
See Fig. 3
6.Turn on water supply, check for leaks and make any final adjustments required.
Spout
Spout nipple
w/O rings
Decorative Ring**
Quick connect
Dock flange
Setscrews
Handle
Bonnet**
Escutcheon**
Valve
Fig. 3
** Optional item based on model selected
[phone]
Santa Ana, Ca. 92705
www.newportbrass.com
NWP-1-502
03/08/2018
SERIES
3-806 3-816 3-826
3-836 3-842 3-846 3-856 3-916 3-926
3-936 3-986
3-996(L)
3-1006 3-1036 3-1206
3-1406(L)
3-1506
3-2016
3-2026
3-2106
3-916
STEP
HEIGHT
2-1/2"
2-3/4" 2-1/4" 2-1/4" 2-3/4"
2-1/2"
2-3/8" 2-3/4" 2-1/4"
2-1/4"
2-7/16"
2"
2-1/4"
2-1/4"
2-5/16"
2"
2-1/8"
2-7/16"
2-1/2"
2-1/4"
2-5/16"