Installation Guide

3.Attach hot/cold valves to spout, utilizing ¾" copper pipe. See Fig. 2

Fig. 2

Inlet for hot

water supply

Inlet for cold

water supply

Spout nipple

to be used

with trim

installation

See table for

stem height

Washer nut

Deck Flange

Spacer

1-1/4”

3/4” NPT

3/4”

NPT

Fig. 1

Finished Deck

1/2”NPT

NWP-1-503

Rough in valve Installation

Recommended Installation by a Professional Plumbing Contractor

Note: Use Teflon tape or equivalent to seal all threaded joints.

Warning:To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4"

from ports.

1. Install the quick connect spout shank through center hole of mounting surface. Secure with washer nut.

See Fig. 1

2. Place washer nut on valve body. Insert body, (blue cold & red hot), through hole from below mounting sur-

face. See Fig. 1. Adjust and secure with additional washer nut so that the top of valve stem is at the correct

height from mounting surface. See Table 1.