Manual

ManualsBrandsNewport Brass ManualsFor Home3-1687 Virginia

ROMAN TUB 3 VALVE TRIM

INSTALLATION INSTRUCTIONS

Valve Model No: 1-548A

Trim Kit for Model No: 1687

Congratulations on the purchase

of this Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

Summary of content (4 pages)

PAGE 1
ROMAN TUB 3 VALVE TRIM INSTALLATION INSTRUCTIONS Valve Model No: 1-548A Trim Kit for Model No: 1687 Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use Teflon tape or equivalent to seal all threaded joints. Plumb with 3/4” copper pipe, as shown below, is recommended. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. 2. 3. 4. 5. Install the spout quick connect shank through spacer and appropriate hole of mounting surface. Secure with washer nut. See Fig.
PAGE 3
Trim Installation Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 1. Attach handle and diverter trim to valves. Any adjustments for rotational alignment must be made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to prevent damage to the surface finish.) Secure handles into place with setscrew. 2.
PAGE 4
Disclaimer Regarding Brasstech Roman Tub with Hand Spray To conform to local codes and ordinances, all Brasstech Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).